Maintenance work of gummy manufacturing machine

News

Maintenance work of gummy manufacturing machine

As the running time of the gummy manufacturing machine increases, the entire performance of the machine will cause a decline, so it is difficult to achieve stable work. If the manufacturer continues to work, it will also cause serious material waste, which cannot bring any development to the manufacturer. Space and maintenance work can fully solve these problems. The following is a detailed introduction to the maintenance work of gummy manufacturing machine:

The frequency of use is here to remind everyone that there is a limit to the use of equipment, and it is not possible to run endlessly. Many manufacturers will use the frequency of the equipment to exceed the operating limit of the equipment, although it can get a good market value, but this way It has a huge impact on the service life of the equipment. Often, the equipment is almost scrapped before it reaches the service life. Therefore, it is very important to properly control the use frequency of the equipment, so that the equipment can be alleviated and more production and processing can be completed.

Troubleshooting, according to the analysis of previous cases, as long as the equipment fails, it needs to be solved immediately, and even if it cannot be solved, the equipment must be shut down. In fact, many small faults are caused by the accumulation of these small problems, and the problems should Fix it now.

Dust cleaning, long-term use of gummy manufacturing machines will leave a lot of dust. If the equipment is covered with dust and continues to work, it will not only affect the safety of candy and food, but also have great problems with the heat dissipation of the motor. Continuing to complete processing at high temperature has a serious impact on the service life of the motor. It is very important to perform necessary maintenance work. Clean all the dust on the outer layer of the equipment, so that the operating temperature of the motor can be released, even if continuous processing will not affect the motor.


Post time: Jul-28-2023